The pitter-pat of tiny little feet


The Triggertrap v1 normally stands on its screws, but David reminded me of a hack I've been meaning to do for a while: Give it better feet! I have developed a little bit of a Sugru addiction recently, so I decided that this was as good a reason as any to break open another packet and do a bit of hacking. There's a step by step guide below, but it can be easily summarised as: "Add sugru. Leave to cure".

Still reading? Oh, you time-waster, you. Okay, then:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Step 9

When the Sugru is fully cured, you can take the pieces of packaging off. Best of all, you can now remove the feet from the screws if you need access to the screws, and since they are all perfectly molded, they'll just slip back onto place when you've re-assembled your Triggertrap. Clever, eh?

2 Comments